Guido Pfister 1 Comment

Being well known for our repair capabilities, we repair damaged two- and four-stroke engine flywheels frequently. In most cases, a few of the flywheel’s teeth are damaged and we quickly restore these by installing a tailor-made repair insert. We usually do this in-situ, either during a port stay or during a docking.

The situation found on an European-owned 2’300 TEU box ship in September 2022 was very different. When the customer contacted us about a damage to the flywheel, we sent our colleagues from QuantiServ Singapore on board for an inspection.

Badly damaged flywheel

During the inspection it very quickly became clear that this was no ordinary case, as all ninety teeth were found severely damaged. An in-situ repair of 90 teeth would take too long and would not be cost-efficient either. As the ship was about to be docked very soon, we suggested to the customer to carry out the repair during the upcoming docking in southern China.

The colleagues from QuantiServ China took over the case. They worked out a very attractive proposal that was immediately accepted by the customer. Our engineers and technicians then started all preparation and planning.

Once the vessel was in the yard, the yard workers uncoupled the intermediate shaft, took the 3.5 ton flywheel off the engine and moved it out of the engine room through a narrow slot that they had cut into the vessel’s hull. The flywheel was then trucked to Shanghai, where the highly-skilled engineers and technicians from QuantiServ China immediately commenced to machine it.

They machined off its toothed rim and then shrunk on a tailor-made ring of forged steel onto the ø 3.2 meter flywheel. And to make sure that the ring stays put for the lifetime of the ship, they also installed a total of 135 large bolts. Once this was completed, new teeth were milled.

Milling new teeth obviously took time, owing to the large size of the flywheel. In fact it took five days and five nights of continuous milling!

After completing a few more processing steps, our Shanghai colleagues sent the flywheel back to the shipyard and to a very happy customer. The shipyard workers then completed this repair assignment, by reinstalling the flywheel to the 72-bore engine and by re-coupling it to the ship’s intermediate shaft.

Severely damaged flywheel prior to repair
Severely damaged flywheel prior to repair
Milling of new teeth
Milling of new teeth
Ready to be delivered back to the shipyard
Ready to be delivered back to the shipyard
Machining on a large vertical lathe
Machining on a large vertical lathe
The newly milled teeth
The newly milled teeth
During re-installation on board
During re-installation on board

Links

The repair of every single tooth on a flywheel as presented above is not something that we do every day. Typically, just a handful of consecutive teeth are damaged. Follow one of the links below to see how we repair these cases in-situ.

Flywheel In-situ Repair on the US East Coast

Another successful flywheel repair assignment completed, in Florida, USA

View more

Flywheel Teeth Dentistry in Hong Kong

In-situ repair of a large 96-bore engine flywheel at Hong Kong anchorage

View more

In-situ Flywheel Repair in Mombasa, Kenya

In-situ Flywheel Repair on a 3’400 TEU Container Vessel in Mombasa, Kenya

View more

— One Comment —

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.